Features
see in the link below
https://revolutionpi.de/analoges-digitales-io-modul
8 Analog Outputs
8 Analog Inputs
4 Digital Inputs or Outputs
Overview Interface
https://revolutionpi.com/tutorials/pin-belegung-core-2
Setup Configuration
select your main module in PiCtory and drag to the right or left side, depending on which device you have, the RevPi MIO
Configure the RevPi MIO
the RevPi MIO is a combination of the RevPi AIO and the RevPi DIO. In the following, we show how the Analog and digital inputs can be configured.
Troubleshooting
https://revolutionpi.com/tutorials/images/firmware-update
Analog Interface
Analog Input for Voltage Measurement
if you want to measure the Analog value from an input
set the AnalogInputMode1 = analogInput
read value:
piTest -r AnalogInput_1
Analog Input for Level Detection
If you are looking for a voltage threshold, then set the following.
AnalogInputMode1 = LogicLevelInput
Required switching threshold in millivolts.
InputLogicLevelVoltage_1= x
this is the voltage level detection
piTest -r AnalogInput_1
For more information, read the following article:
https://revolutionpi.com/tutorials/analoge-eingaenge-konfigurieren-2?noredirect=en-US
Digital Interface
the digital interfaces (4 pins) on the top of the RevPi MIO can be configured individually. Each can be set as input or output, also the mode can be configured.
For the configuration, see the following link. There is described how to configure the RevPi DIO/DI/DO.
Commissioning RevPi DIO | DI | DO
Further Information
https://revolutionpi.com/tutorials/pin-belegung-core-2?noredirect=en-US