Skip to end of banner
Go to start of banner

High-Side

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Features

all 14 output ports can supply 500mA simultaneously, in highside mode.

If the module gets too warm, all ports are switched off. This prevents the device from being damaged.

https://revolutionpi.com/forum/viewtopic.php?t=3389

Wiring

Connect The RevolutionPi DIO as in the Following picture

  1. connect 12 V - 24 V on X4, on the Bottom of the device

  2. connect 12 V - 24 V on X2 for Input, on the Top of the device

  3. connect 12 V - 24 V on X2 for Output, on the Top of the device

  4. connect all Grounds

  5. connect one port from Output 1 to 14 to the electrical consumer [M], [M] can be a 24V LED

  6. Set the ground from the electrical consumer [M] to the same ground as the RevolutionPi

PiCtory Configuration

The following describes how to set up the PiCtory configuration to run the DIO in High-Side mode.

For this example, you can use a RevolutionPi Core or Connect. The only difference for this example is which base module is inserted into PiCtory.

  • No labels