When it comes to testing whether there is a hardware or software problem, this article is right.
Preparation
Please answer the following questions
Your application uses
- LabVIEW
- Windows C/C++
- Linux
Please check the minimum requirements for the use of the drivers
- LabVIEW - https://www.ni.com/de-de/support/documentation/compatibility/16/ni-visa-and-labview-version-compatibility.html
- Windows - Version 10
- The most actual Configurator III software version 3.1.2
- This software is provided by the WINDOWS Device Drivers. Please contact support@kunbus.com for the provision of a download.
- Linux - have a look at the driver cd index.html page
Instruction
Open https://www.kunbus.com/pc-cards-profibus-df-profi-ii.html
Download the “Getting Started document” according to your target application
Follow the instructions
Check the LEDs on the DF PROFI II hardware
Check
Check the status of the LEDs
LED | Status |
|---|---|
Green | ON |
Yellow | ON |
Red | OFF |
Evaluation
If the check is negative please proceed with