Features
all 14 output ports can supply 500mA simultaneously, in highside mode.
If the module gets too warm, all ports are switched off. This prevents the device from being damaged.
https://revolutionpi.com/forum/viewtopic.php?t=3389
Wiring
Connect The RevolutionPi DIO as in the Following picture
...
connect 12 V - 24 V on X4, on the Bottom of the device
connect 12 V - 24 V on X2 for Input, on the Top of the device
connect 12 V - 24 V on X2 for Output, on the Top of the device
connect all Grounds
connect one port from Output 1 to 14 to the electrical consumer [M], [M] can be a 24V LED
Set the ground from the electrical consumer [M] to the same ground as the RevolutionPi
PiCtory Configuration
The following describes how to set up the PiCtory configuration to run the DIO in High-Side mode.
For this example, you can use a RevolutionPi Core or Connect. The only difference for this example is which base module is inserted into PiCtory.