High-Side

Features

all 14 output ports can supply 500mA simultaneously, in highside mode.
Only all outputs can be operated in high-side mode.

If the module gets too warm, all ports are switched off. This prevents the device from being damaged.

https://revolutionpi.com/forum/viewtopic.php?t=3389

Wiring

Connect The RevolutionPi DIO as in the Following picture

1. connect 12 V - 24 V on X4, on the Bottom of the device

2. connect 12 V - 24 V on X2 for Input, on the Top of the device

3. connect 12 V - 24 V on X2 for Output, on the Top of the device

4. connect all Grounds

5. connect one port from Output 1 to 14 to the electrical consumer [M], [M] can be a 24V LED

6. connect the ground from the electrical consumer [M] to the same ground as the RevolutionPi

Connect the extension module with a base module

Connect the RevolutionPi DIO to the RevolutionPi Connect with a PiBridge.

PiCtory Configuration

The following describes how to set up the PiCtory configuration to run the DIO in High-Side mode.

For this example, you can use a RevolutionPi Core or Connect. The only difference for this example is which base module is inserted into PiCtory.

Set output to high-Side

Save the config like in the picture below, with “Save as Start-Config“

Switching output with piTest from piControl

Check if Device is recognized correctly.

piTest -d

Found 2 devices:

Address: 0 module type: 105 (0x69) RevPi Connect V1.0
Module is present
     input offset: 113 length: 6
    output offset: 119 length: 5

Address: 31 module type: 96 (0x60) RevPi DIO V1.4
Module is present
     input offset: 0 length: 70
    output offset: 70 length: 18

Control of the DIO continually