Skip to end of banner
Go to start of banner

Firmware Update Ethernet Based Modular Gateway Module

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

This manual is only suitable for the following Modular Gateway modules:

Protocol

Article No.

Gateway module PROFINET IRT Slave

100074

Gateway module Ethernet/IP Slave

100066

Gateway module POWERLINK Slave

100076

Gateway module EtherCAT Slave

100073

Gateway module Sercos III Slave

100075

Gateway module Modbus TCP Slave

100088

Files needed

Please request the required files from the KUNBUS Support team.

Instructions

Make sure that the module is not disconnected from the power supply during the process

  1. Set IP address

  2. Connect to the module with a FTP program e.g. FileZilla.

    1. User: Admin

    2. Password: 1701

  3. Copy the KFU file into the root directory

  4. Copy the content of the folder "targetfiles" into the root directory

  5. Wait until all transfers have been completed successfully

Reboot

  1. Now disconnect the device from power for at least 5 seconds

  2. Reconnect the circuit for at least 1 minute

Check

You can check the firmware version via

  • Login on the web frontend

  • No labels