...
https://revolutionpi.com/tutorials/pin-belegung-core-2?noredirect=en-US
FAQ
Is there a tutorial on how to make an LED flash or connect a button?
Yes, here is a simple tutorial:
...
I am using the RevPi MIO module and sometimes the
...
IN LED is red and stays that way until I reboot the system, what can I do?
Pull all unused analog inputs to GND via a wire jumper.
Would it be possible to use the outputs of the RevPi MIO Module to switch a relay?
The RevPi MIO can drive max. 40 mA. It is best to try it out with the specific relay type, as the current consumption of relays is not linear.
When the RevPi MIO module is switched on, there are peaks on the outputs. What can I do to prevent this?
Please update the firmware of your RevPi MIO modules as follows:
| Code Block | ||
|---|---|---|
| ||
sudo apt update
sudo apt install revpi-firmware
piTest -f |