...
The PiBridge interface and the PiControl driver are documented here:
...
The product description of the RevPi Flat states that up to three devices can be connected to the network via the Eth1 interface. How does this work?
as it mentioned in the picture, there are 2 different interfaces:
...
is an RJ45 Jack
is a LAN/SWITCH to which you can connect your 3 devices.
Under this link you will find the descriptions :
I have a project to build my own hardware and connect it to the Revolution Pi master module like Connect + or Core. How can I proceed?
...
Yes, an RTC is installed in the RevolutionPi Core devices. The system time is buffered for 24 hours without an external power supply. This was implemented with the use of a Supercapacitor.
https://revolutionpi.com/revpi-core-part-1/?noredirect=en_US
RTC error message after prolonged non-use of the Revolution Pi
...
| View file | ||
|---|---|---|
|
Is it possible to install a new image on the RevPi Flat?
Yes, if you buy a CM3 I/O board
https://www.raspberrypi.com/products/compute-module-io-board-v3/
and follow these instructions
...
|
Would it be possible to install a new image on the RevPi Flat?
Is there any information about the performance of the RevPi?
Yes, we have some Information in the links below:
https://revolutionpi.de/forum/viewtopic.php?f=3&t=3309#p11965
http://donar.messe.de/exhibitor/hannovermesse/2017/A167098/revolution-pi-zeitung-ger-480244.pdf
https://cdn-reichelt.de/documents/datenblatt/C300/REVPI_MAN_DE.pdf
https://revolutionpi.com/pictory-neues-revpi-core-v1-2-jessie/?noredirect=en_US
...
What is the RJ11 pin assignment of the RevPi Flat?
...
What size circuit breaker would you recommend for the power supply for the RevPi?
...